(908) 774-2221 Get my estimate

Beam clear

Garage door repair and installation across North Jersey and Central Jersey

Broken springs, frayed cables, off track doors, dead openers and misaligned sensors, repaired at your home or business by appointment at any hour.

Get my estimate Call (908) 774-2221

A written estimate is agreed before any work begins.

What we fix and install

Six services, one standard. Every visit begins with a full diagnostic of the springs, cables, rollers, tracks, opener and safety sensors, and ends with the door cycled and the auto reverse tested in front of you.

Illustration of torsion springs on the shaft above the door
Illustration: torsion springs on the shaft above the door

The weight is the whole problem

A garage door can weigh several hundred pounds, and it is the springs, not the opener, that hold that weight. When a spring loses tension the opener strains, the door starts to slam, and every roller, cable and hinge wears faster than it should. Replacing the springs and rebalancing the door is what makes the rest of the hardware last.

All services

If the door is stuck or a spring has snapped

What happens in the first few minutes decides whether the job stays a spring replacement or turns into a door, a track and a cable job.

Call (908) 774-2221

The phone is answered at any hour. Visits by appointment.

Before anyone touches the door

  1. Leave the opener alone

    Do not press the button again, and unplug the opener so nobody runs it by habit. Every cycle with a broken spring drags the door on one side and can throw a cable off its drum.

  2. Keep people and cars clear

    Keep everyone out of the doorway and do not lift the door by hand. If a car is inside, leave it there: a technician raises the door with the broken side supported.

  3. Call (908) 774-2221

    Describe what you see and, if you can, photograph the spring or the track. The photo is useful when you call.

How a visit goes

The same four stages on every job, from the first call to the last cycle of the door.

Illustration of a two car garage at night with the red safety beam across the threshold
Illustration: the photo eye beam across a closed door at night

  1. Contact us

    Call, or send the form with a photograph or a short video of what the door is doing. We answer any hour and set a visit at a time that suits you.

  2. Diagnosis and written price

    The technician inspects the springs, cables, rollers, tracks, opener and safety sensors, explains what failed and why, and gives you the written price before any part comes off the door.

  3. The repair

    The failed part is replaced or repaired with the door secured. Torsion springs are changed as a pair with calibrated winding bars, and the door is rebalanced so it stays where you leave it.

  4. Test and walk through

    The door is run through full cycles, the photo eyes and the auto reverse are tested, and we walk the result with you before leaving. The work area is cleaned up and the old parts are taken away.

Spring replacement
Usually one to two hours on site
Recommended check
A safety inspection once a year
Hours
24 hours a day, by appointment

What we check on every visit

A garage door is the largest moving part of a house, and when something lets go it rarely fails alone. So the visit covers the whole door, not only the part that made the call.

A spring that snaps usually took a frayed cable or a worn roller with it, and an opener that reverses for no reason often has sensors out of line rather than a board fault. We diagnose before we quote, so the price covers the actual failure.

Our rule on every job: the door has to be safe to walk under, and the auto reverse has to pass its test, before the work is called finished.

Illustration of gloved hands checking a garage door section with a level
Illustration: checking level and balance on a door section

  • Springs

    Tension, balance and the condition of both springs.

  • Cables

    Cable condition and drum seating, wound evenly on both sides.

  • Rollers

    Roller wear across every section, nylon or steel.

  • Tracks

    Track alignment, hinges and the brackets that hold it all.

  • Opener force and reverse

    Force and travel limits, then the auto reverse test with an object laid flat in the door's path.

  • Sensor alignment

    Photo eyes lined up, so the beam stops and reverses a closing door.

The 12 point safety inspection goes further: the emergency release, hinge integrity, bracket fastening, the weather seal and a balance test of the door, with every finding in writing.

Eight counties, 228 towns

We cover Bergen, Essex, Hudson, Middlesex, Morris, Passaic, Somerset and Union counties. All work is performed at your home or business, and bookings are taken at any hour.

There is no storefront and no street address to visit, because every job happens at the property where the door stands.

Illustration of a New Jersey street at blue hour with houses and garage doors
Illustration: a New Jersey street at blue hour

Service area

228 towns

Every job at the property

Point at a county, or use the list, to see its towns.

Plan
AMG Garage Door Expert service area, New Jersey
County outlines
U.S. Census Bureau, TIGERweb
Town centres
Wikipedia coordinates

Tell us what the door is doing

Send the details and we will reply with a written estimate the same day, or call and speak directly with the technician who performs the work.

No obligation. The phone is answered at any hour.

(908) 774-2221

Rather pick a time?

Choose a day and a time window. We call to confirm.

Illustration of a lit garage door wall button
Illustration: the wall button inside the garage
Amber
Needed
Green
Clear
Red
Check this one

Estimate request

6 required fields waiting

What needs the work? (pick at least one)

Photographs of the door (optional, up to 5, 8 MB each)

A photograph of the door or the opener helps us give an accurate estimate.

    Both boxes are optional. You can send the form without ticking either.

    A quick check that you are a person, from Cloudflare. It sets no cookie for advertising and does not track you across sites.

    We reply the same day.

    Frequently asked questions

    More answers on springs, sensors, noise and booking are on the FAQ page.

    How often should a garage door be serviced?

    Once a year for most homes. A safety inspection checks spring tension, cable condition, roller wear, track alignment and the auto reverse, and catches the worn part before it breaks the door and strands the car.

    How long does a repair take?

    Most common failures are finished in one visit. A torsion spring pair is usually one to two hours on site, and opener or sensor work is often faster. The written estimate says what the visit covers before any work begins.

    The door opens and then will not close. What is wrong?

    Usually the safety sensors. Photo eyes mounted a few inches off the floor stop the door when the beam between them is broken, and a bumped bracket, a spider web or low sun can fool them. Realignment is a small job, and it is checked with a proper reverse test before we leave.

    Can you come in the evening or at night?

    Yes. We book by appointment around the clock, and evening visits are routine because most households are out during the day.

    Do you sell and install new doors too?

    Yes. New door installation is one of the six services: steel, insulated, aluminum, glass and wood composite doors, with the old door taken away, the tracks aligned and the opener programmed to the new door.

    A spring broke and the door is stuck. What should I do first?

    Stop using the door. Do not try to lift it by hand, keep everyone away from it, and leave the opener alone until the springs are replaced. A spring replacement visit rebalances the door properly, and what to do in the first minutes is set out in the spring guide on the blog.

    Garage door guides

    All eight guides
    Call Estimate